24.RFID Doorlock system

Projek arduino RFID Doorlock system ini adlah bertujuan untuk membuka dan mengunci pintu dengan menggunakan RFID card.

Gambar Projek adalah seperti dibawah:

Video Projek:

Berikut adalah video projek yang lebih mudah difahami:


Block Diagram:
Komponen yang digunakan:
1-JUMPER CABLE (MALE-MALE)------------(QTY: 1)- KLIK SINI
2-JUMPER CABLE (MALE-FEMALE)--------(QTY: 1)- KLIK SINI
3-JUMPER CABLE (FEMALE-FEMALE)----(QTY: 1)- KLIK SINI
4-ADAPTOR-----------------------------------------(QTY: 1)- KLIK SINI
5-ARDUINO UNO----------------------------------(QTY: 1)- KLIK SINI
6-EXTENDER---------------------------------------(QTY: 1)- KLIK SINI
7-RFID READER-----------------------------------(QTY: 1)- KLIK SINI
9-RELAY 1 CHANNEL----------------------------(QTY: 1)- KLIK SINI
10-SOLENOID---------------------------------------(QTY: 1)- KLIK SINI
11-LCD16X2------------------------------------------(QTY: 1)- KLIK SINI
12-PUSH ON SWITCH-----------------------------(QTY: 1)- KLIK SINI
13-RESISTOR 470OHM---------------------------(QTY: 3)- KLIK SINI
14-LED RED------------------------------------------(QTY: 1)- KLIK SINI
15-LED GREEN-------------------------------------(QTY: 1)- KLIK SINI
16-LED YELLOW-----------------------------------(QTY: 1)- KLIK SINI

Kami ada menjual semua komponen yang disenaraikan seperti di atas

 Litar projek adalah seperti di bawah :

1 comment:

  1. lizza kim23 November 2018 at 21:40

    These are actually wonderful some ideas in the blog. You have touched good quality points here. In whatever way continue writing.low rate locksmith 91911

    ReplyDelete

Subscribe to: Post Comments (Atom)
Related Posts Plugin for WordPress, Blogger...